Autodesk Inventor – Generating Cables and Harnesses
Thursday, 25 June 2020
Autodesk Inventor’s Cable and Harness environment allows for easy generation of electrical connections in a mechanical assembly. Generating a wiring set is as easy as designating electrical “pins” onto various
- Published in Autodesk Inventor, Product Design and Manufacturing
No Comments
Autodesk Inventor – Sketching in 3D
Thursday, 14 May 2020
Most of us are familiar with sketching in Inventor. You pick a plane or a flat surface, draw your profile, provide linear references such as paths or rails and you’re
- Published in Autodesk Inventor, Product Design and Manufacturing
Autodesk Inventor – All About 3D Fillets
Wednesday, 11 March 2020
If you spend quite a bit of time modeling in Inventor, chances are you’ve made good use of fillets. This pick-and-place tool is an invaluable time saver for creating the
- Published in Autodesk Inventor, Product Design and Manufacturing
Stress Analysis using Autodesk Inventor
Wednesday, 12 February 2020
- Published in Autodesk Inventor, Product Design and Manufacturing
Autodesk Inventor – Modeling with Surfaces
Tuesday, 05 November 2019
When you extrude a loop from a sketch, the result is usually a solid. However, you can also generate surfaces using Inventor’s modeling commands. Unlike solid modeling, surface modeling does
- Published in Autodesk Inventor, Product Design and Manufacturing
Freeform Modeling in Autodesk Inventor
Monday, 07 October 2019
- Published in Autodesk Inventor, Product Design and Manufacturing
Autodesk Inventor Design Accelerator – Mechanical Design Made Simple
Thursday, 12 September 2019
Often times a design calls for a custom-made version of a standard component. When it comes to gears, springs, and fasteners, many standards exist for a wide variety of design
- Published in Autodesk Inventor, Product Design and Manufacturing